Short Lead Time for Dry Powder Magnetic Separator - GTXS Chamber Type Filter Press – Guote

Product introduction:
The wing filter press USES the pressure difference between the two sides of the filter cloth to force most of the moisture in the material to flow through the filter cloth and out of the body, while the material is blocked in the filter chamber to form a filter cake to achieve the purpose of filtration.Because there is a big pressure difference between the two sides of the filter cloth in the filtration process, the filtration speed is increased, the moisture content of the filter cake is reduced, and a special filter cloth is adopted to make the filtrate clear and the filtration effect is much better than that of the vacuum filter.
Application:
Mainly used in tailings sludge treatment and desizing.
Highlight the advantages of
Wear little
The function of removing iron is continuous and constant
Environmental protection
Suitable for closed powder conveying system, no dust escaping and no pollution to environment
Done automatically
The process of iron removal is continuous and automatic. No special person is required to watch the equipment after starting
Long service life
Nd-fe-b high strength permanent magnet, high iron removal efficiency, long service life
Reasonable structure, occupying space
Reasonable structure, small occupation space, easy installation, series connection in the powder conveying pipeline can be used
The working principle of
The working principle of the chamber filter press is that the filter plates are arranged to form a filter chamber (the two sides of the filter plate are concave and each two filter plates are combined to form a box filter chamber).
The principle is as follows: the surface of the filter plate is pitted and raised to support the cloth.There are through holes in the center and corners of the filter plate, which constitute a complete passage after assembly, and can be used to feed suspension, washing water and extract filtrate.Both sides of the filter plate are supported by a handle on the beam, and the filter plate is pressed by a compression device.The press cloth between the filter plates ACTS as a seal.
Under the pressure of the feed pump, the material and liquid to be filtered will be sent to each filter chamber, and the solid and liquid will be separated through the filtration medium (according to the choice of suitable filter cloth for different industries).Filter residue is formed on the press cloth until it fills the filter chamber to form filter cake.The filtrate passes through the filter cloth and flows along the groove of the filter plate to the outlet hole under the filter plate for centralized discharge.After filtration, the filter residue can be washed by cleaning water.After washing, sometimes compressed air is injected to remove the remaining washing liquid.After the filtration, open the filter press and remove the filter cake (the cake is stored between two adjacent filter plates), clean the press cloth and press the plate again to start the next working cycle.
The filter cloth is fixed on the board frame, which is the main form of filter press in the early stage.Box pressure filter in the filter chamber is made up of two adjacent sag filter plate, filter cloth fixed on each filter plate, box pressure filter’s main advantage is higher efficiency, effect is better, filter plate is relatively durable () in the same conditions, but are high degree of automation, clean the filter cloth have automatic device, change the number of filter cloth is generally not frequently.

• Classic Wet Magnetic Separator
• Double Drum Type Magnetic Separator
• Dry Type Magnetic Roller Separator
• Iron Ore Drum Magnet Separator
• Plate Magnetic Separator
• Quartz Production Line